Filter
Top Products
116
Remote Commander
ADATA CODE button (75)
Displays the date and time or camera setting
data of the recorded images when you press this
during playback.
BPHOTO button (30)
The on-screen image when you press this
button will be recorded as a still image.
CSCAN/SLOW buttons (36)
D. > (Previous/Next) buttons (36)
EPLAY button (36)
FSTOP button (36)
GDISPLAY button (17)
HTransmitter
ISTART/STOP button (30)
JPower zoom buttons (31, 39)
KPAUSE buttons (36)
LVISUAL INDEX button (35)
Displays a VISUAL INDEX screen during
playback.
M b / B / v / V / ENTER buttons
When you press any button on the [VISUAL
INDEX]/[Film Roll Index]/[Face Index]/
Playlist screen, the orange frame appears on the
LCD screen. Select a desired button or an item
with b / B / v / V, then press ENTER to enter.
b Notes
• Remove the insulation sheet before using the
Remote Commander.
• Point the Remote Commander towards the remote
sensor to operate your camcorder (p. 113).
• When no commands have been sent from the
Remote Commander within a certain period, the
orange frame disappears. When you press any of
b / B / v / V, or ENTER again, the frame appears
at the position where it was displayed last.
• You cannot select some buttons on the LCD
screen using b / B / v / V.
To change the battery of the Remote
Commander
1 While pressing on the tab, inset your
fingernail into the slit to pull out the battery
case.
2 Place a new battery with the + side facing
up.
3 Insert the battery case back into the Remote
Commander until it clicks.
• When the lithium battery becomes weak, the
operating distance of the Remote Commander
may shorten, or the Remote Commander may
not function properly. In this case, replace the
battery with a Sony CR2025 lithium battery.
Use of another battery may present a risk of fire
or explosion.
WARNING
Battery may explode if mistreated. Do not
recharge, disassemble or dispose of in
fire.
Insulation sheet
Tab