Filter
Top Products
COLOR CCD CAMERA User’s Manual
39
COLOR CCD CAMERA User’s Manual
38
PRIVACY : Hide an area you want to hide on the
screen.
When the SPECIAL menu screen is displayed,
press the Up and Down buttons so that the
arrow indicates ‘PRIVACY’.
When the SPECIAL menu screen is displayed, press the Up and Down buttons
so that the arrow indicates
MOTION DET .
Set up the mode using the 4 direction buttons.
- SENSITIVITY : You can select up to 8 MD areas.When SENSITIVITY number is high,
motion detection sensitivity is increased to recognize even small movement.
- AREA MODE : Determines whether to use the MD area selected in SENSITIVITY.
- SEL POS : Determines which of the 4 vertices of each MD area is to be used.
- YPOS : Determines the coordinate of the vertical axis for SEL POS.
- XPOS : Determines the coordinate of the horizontal axis for SEL POS.
- FILL
SET : Fills in a selected MD area. Fills in a selected MD area. The color of filling is
sequentially selected as brown, orange, blue, cyan, yellowish green, yellow
and red.
- RETURN : Select this to save the MOTION DET menu settings and return to the SPECIAL
menu.
Enter a title, move the cursor to ’POS’ and
press the SET button. The entered title
appears on the screen. Select the position to
display the title on the screen by using the 4
direction buttons and press the SET button.
When the position is determined, select
’END’ and press the SET button to return to
the SPECIAL menu.
•
When using AC power at 60Hz frequency, you can use the L/L type synchronization.
• When the power is DC 12V, the SYNC. menu is fixed to the ‘INT’ mode.
Notes
•
MD areas show only MOTION DET menu. Therefore, MD areas don’t display on the
monitor screen.
Notes
How to Use the Camera
MOTION DET:
If you connect an alarm device to this camera, you
can monitor activity more efficiently, because a
signal is generated by the camera whenever
motion is detected. The motion detection signal is
output through the MD OUT port.
Set up the mode using the 4 direction buttons.
- AREA SEL : You can select up to 8 MD areas.
- AREA MODE :
Determines whether to use the area selected in
the AREA SEL, and the size and position of the
area.
SYNC :
In areas where the supply is at 60Hz, you can
synchronize the output phase of multiple
cameras using the power synchronization
function (Line-Lock) without using a
synchronization signal generator.
- INT : Internal Synchronization Type
- L/L : Power Synchronization Type, Line-lock
• Press the SET button.
• You can select a desired phase from 0 to 359 when select 'phase'.
• You can decide the synchronization between luminance and color signal when
select the 'mode'.
to Locate, then SETto Locate, then SETto Locate, then SET
FRONT DOOR