Filter
Top Products
83
Additional information / Información adicional
Cause and/or corrective actions
• The battery pack is not installed.
m Install the battery pack. (p. 10)
• The battery is dead.
m Use a charged battery pack. (p. 7)
• The AC power adaptor is not connected to a wall outlet.
m Connect the AC power adaptor to a wall outlet. (p. 27)
• If the power is still not on after you tried the corrective actions
above, press the RESET button on the camcorder using a
sharp-pointed object. (If you press the RESET button, all the
settings including the date and time return to the default.)
(p. 95)
• While being operated in CAMERA mode, the camcorder has
been in Standby mode for more than 5 minutes.
m Set the POWER switch to OFF, then to CAMERA. (p. 13)
• The battery is dead.
m Use a charged battery pack. (p. 7)
• The ambient temperature is too low. (p. 74)
• The battery pack has not been charged fully.
m Charge the battery pack again. (p. 7)
• The battery pack is completely dead, and cannot be recharged.
m Use another battery pack. (p. 27)
• The camcorder does not operate when using a battery that is
not an InfoLITHIUM battery pack.
m Use an InfoLITHIUM battery pack. (p. 7)
Cause and/or corrective actions
• The tape is stuck to the drum.
m Eject the tape. (p. 11)
• The tape has run out.
m Rewind the tape or use a new one. (p. 21)
• The POWER switch is set to VTR.
m Set it to CAMERA. (p. 13)
• The tab on the cassette is out (red).
m Use a new tape or slide the tab. (p. 11)
• The battery is dead.
m Use a charged battery pack or the AC power adaptor.
(p. 7, 27)
• Moisture condensation has occurred.
m Remove the cassette and leave the camcorder for at least 1
hour. (p. 78)
• Reset the date and time. (p. 71)
• The cassette was ejected after you recorded on it.
m The End Search function will not activate until you make a
new recording after reinserting the cassette.
English
Trouble check
If you run into any problem using the camcorder, use the following table to troubleshoot the problem.
Should the difficulty persist, disconnect the power source and contact your Sony dealer or local
authorized Sony service facility.
Camcorder
Power
Symptom
The power is not on.
The power goes off.
The battery pack is quickly discharged.
Operation
Symptom
START/STOP does not operate.
The cassette cannot be removed from
the holder.
{ and 6 indicators flash and no function
except for cassette ejection works.
The date or time indicator displays bars
(--:--:--).
The End Search function does not
activate.