Filter
Top Products
42
Optimizing the recording condition
Use this feature to check the tape condition before recording, so that you can get the
best possible picture (ORC).
(1) While the camcorder is in Standby mode, press MENU to display the menu.
(2) Turn the control dial to select ORC TO SET, then press the dial.
“START/STOP KEY” starts flashing.
(3) Press START/STOP.
The ORC indicator starts flashing. The camcorder takes about 10 seconds to
check the tape condition and then returns to Standby mode.
If the cassette has been ejected
Every time you eject the cassette, ORC is canceled. Set ORC again.
To check if you have performed ORC
If the ORC indicator lights up in the display window, the tape condition has been
checked.
Notes on the ORC function
•When you set ORC TO SET, the recording on the tape is erased for about 0.1 second so
that the camcorder can check the tape condition. Be careful when you use a recorded
tape. The 0.1 second blank is erased if you record from the point where you set ORC
TO SET for more than 2 seconds, or if you record over the blank.
•You cannot use this function on a tape with the red mark on the cassette exposed.
•While the ORC function is turned on, you cannot operate the power zoom lever.
3
1
2
MENU
COMMANDER
ORC TO SET
REC MODE
WIND
TITLE COL
TITLE POS
TITLE LANG
[MENU] : END
START/STOP
KEY
ORC
STBY
0:00:00
40 min
.
START/STOP
L
O
C
K
S
T
A
N
D
B
Y
SEL/PUSH EXEC
SEL/PUSH EXEC
MENU
12