Filter
Top Products
57
Additional Information
Trouble check
Symptom
Recording stops in a few
seconds.
The cassette cannot be
removed from the holder.
{ and 6 indicators flash and
no function except for cassette
ejection works.
The counter, date or time
indicator is flashing.
The tape does not move when
a video control button is
pressed.
The SteadyShot function does
not activate.
The autofocusing function
does not work.
The fader function does not
activate.
No sound or only a low
sound is heard when playing
back a tape.
Excessive high-pitched sound
is heard.
The date or time indicator
disappears.
Cause and/or Corrective Action
• The START/STOP MODE switch is set to 5 SEC or ANTI
GROUND SHOOTING .
m Set it to . (p. 15)
• The battery is dead.
m Use a charged battery pack or the AC power adaptor.
(p. 6, 22)
• Moisture condensation has occurred.
m Remove the cassette and leave the camcorder for at least
1 hour. (p. 52)
• You pressed DATE and TIME together for more than 2
seconds.
m The camcorder is not malfunctioning. You may start
recording. Flashing will stop soon.
• The lithium battery is weak or dead.
m Replace the lithium battery with a new one. (p. 46)
• The POWER switch is set to CAMERA or OFF.
m Set it to VTR.
• The tape has run out.
m Rewind the tape or use a new one. (p. 20)
• STEADY SHOT is set to OFF.
m Set STEADY SHOT to ON. (p. 45)
• The SteadyShot function does not work when the wide
mode is set to 16:9 FULL.
• FOCUS is set to MANUAL.
m Set it to AUTO. (p. 31)
• Shooting conditions are not suitable for autofocus.
m Set FOCUS to MANUAL to focus manually. (p. 31)
• START/STOP MODE is set to 5 SEC or ANTI GROUND
SHOOTING .
m Set it to . (p. 15)
• A title is displayed.
m Stop superimposing the title.
• The stereo tape is played back with HiFi SOUND set to 1
or 2 in the menu system.
m Set to STEREO in the menu system. (p. 26)
• The picture has been recorded with WIND set to ON in the
menu system.
m When there is no wind, set it to OFF. (p. 25)
• Reset the date and time. (p. 47)
(to be continued)