Filter
Top Products
11
WHITE (white balance automatic adjustment)
button and the indicator
Use to adjust the white balance automatically.
Press this button while the W/B BALANCE switch is
set to AUTO. When the adjustment is completed, the
indicator lights up for about five seconds and turns off.
PED (pedestal level) controls
Use to adjust the pedestal level.
Rotate these controls while the W/B BALANCE
switch is set to MANUAL. The R control adjusts the
red component and the B control adjusts the blue
component.
GAIN (video gain) controls
Use to adjust the video output level.
Rotate these controls while the W/B BALANCE
switch is set to MANUAL. The R control adjusts the
red component and the B control adjusts the blue
component.
q; CABLE COMP adjustment section
CABLE COMP (cable compensation) selector
Set this selector to the position according to the length
of the camera cable to be used. The internal cable
compensator performs compensation according to the
position of this selector to eliminate signal
degradation. Set the selector to “25” when the camera
cable length is 10 meters (about 33 feet) or less.
CABLE COMP FINE (cable compensation fine
adjustment) controls
These controls are for fine adjustment of the cable
compensation level of the video signal output from
thew VBS OUT connectors.
If fine adjustment is required after setting the CABLE
COMP selector, rotate these controls using a
screwdriver. The Y control adjusts the Y (luminance)
signal level and the C control adjusts the C
(chrominance) signal level.
qa IRIS (iris adjustment mode) switch
Use this switch to select the iris adjustment mode. Be
sure that the IRIS switch on the video camera is set to
AUTO.
MAN: Iris is adjusted manually with the iris
adjustment control.
AUTO: Iris is automatically adjusted.
qs IRIS (iris adjustment) control
When the IRIS switch is set to MAN, rotate this
control to manually adjust the iris.
When the IRIS switch is set to AUTO, rotate this
control to manually fine-tune the automatic iris
adjustment.
qd MASTER PEDESTAL (master pedestal level
adjustment) control
Use to adjust the master pedestal (master black) level
setting. The master pedestal level is normally not
stored in the camera. However, when the DXC-M7/
M7P Color Video Camera is connected, the master
pedestal level can be stored by setting an internal
switch in the camera.
For details, refer to the operation manual of the video
camera.
qf AUX (auxiliary) operation section
MENU button and the indicator
When this button is pressed, the indicator lights up and
the menu items that are adjusted by the FUNCTION,
DATA, and RESET buttons appear on the monitor
connected to the MONITOR OUT connector. Pressing
this button again turns the indicator off and causes the
current settings made on the unit to appear on the
monitor. Press this button again to make this
information to disappear.
CABLE COMP
YFINE
C
25
50
75
100
150
200
250
300m
AUX
MENU
FUNCTION
DATA
RESET
CABLE COMP selector CABLE COMP FINE controls
MENU button and
the indicator
FUNCTION buttons
DATA buttons
RESET button