Filter
Top Products
17-GB
3 Use the control buttons on the Remote
Commander to select the search condition
and press the center
button.
The images are displayed in index mode in
accordance with the search condition.
For further information, refer to the operating
instructions supplied with the camera.
Switching between HD and SD
You can switch the TV display between high-
definition video (HD) and other than high-
definition video (SD) by pressing the HD/SD button
on the Remote Commander.
Except for DSC-T75/T70/T2.
1 Turn on the power of the camera by
pressing the
(playback) button of
the camera or the POWER button on the
Remote Commander.
2 Press the HD/SD button on the Remote
Commander.
Every time you press the HD/SD button, the
setting will change alternately between HD and
SD.
The HD-OUTPUT lamp (blue) of the Cyber-shot
Station lights up while the HD video is viewed
on a TV.
For further information, refer to the operating
instructions supplied with the camera.
Wide Zoom Display
You can display a still image with an angle of view of
4:3 or 3:2 to those of 16:9 by pressing the W ZOOM
button on the Remote Commander, which is the
same as the wide zoom function of the camera.
For DSC-T75/T70, the Wide Zoom functions
when you press the
button on the Remote
Commander.
Except for DSC-T2.
1 Turn on the power of the camera by
pressing the
(playback) button of
the camera or the POWER button on the
Remote Commander.
2 Press the W ZOOM button on the Remote
Commander.
Every time you press the W ZOOM button, the
setting will change alternately between Wide
Zoom and Normal modes.
The Wide Zoom mode is canceled when you turn
off the camera or the shooting mode is switched.
Some functions of the Remote Commander will
be unavailable when you are using the Wide
Zoom function.
For further information, refer to the operating
instructions supplied with the camera.
Care and maintenance
Clean the Cyber-shot Station with a soft cloth
slightly moistened with water or tepid water, and
wipe the surface with a dry cloth. Do not use any
type of solvent such as thinner, alcohol or benzine
as this may damage the surface.
Changing the battery of the
Remote Commander
WARNING
Battery may explode if mistreated. Do not recharge,
disassemble, or dispose of in fire.
When the lithium battery becomes weak, the
operating distance of the Remote Commander
may shorten, or the Remote Commander may
not function properly. In this case, replace the
battery with a Sony CR2025 lithium battery. Use
of another battery may present a risk of fire or
explosion.
For the State of California, USA only
Perchlorate Material - special handling may apply,
See www.dtsc.ca.gov/hazardouswaste/perchlorate
Perchlorate Material: Lithium battery contains
perchlorate.
CAUTION
Replace the battery with the specified type only.
Otherwise, fire or injury may result.
Replacing the button type lithium
battery
Do not use any batteries other than CR2025.
Pull out the battery holder while pushing the
tab on the holder.
Put a new battery into the holder with its +
side facing upward.
Insert the holder into the Remote
Commander until it clicks.
tab
*