Filter
Top Products
107
Additional Information
6 Attach the eyecup block to the viewfinder,
pushing it straight on until it clicks.
b Notes
• The eyecup block is a precision part. Do not
disassemble it further.
• Do not touch the lens of the eyecup block.
• If you turn the viewfinder lens adjustment lever
after removing the eyecup block from your
camcorder, the lever and lens may come out the
eyecup block. If this happens, replace them as
follows:
1 Attach the lever to the eyecup block in the
position illustrated. Do not turn the lever
before fitting the lens in place.
2 Place the lens in the eyecup block so that
the three projections fit into the respective
grooves.
3 Turn the lever in the direction of the arrow
to insert the lens fully into the eyecup
block.
On charging the pre-installed
rechargeable battery
Your camcorder has a pre-installed
rechargeable battery to retain the date, time,
and other settings even when the POWER
switch is set to OFF (CHG). The pre-
installed rechargeable battery is always
charged while your camcorder is connected
to the wall outlet via the AC Adaptor or
while the battery pack is attached. The
rechargeable battery will be fully
discharged in about 3 months if you do
not use your camcorder at all. Use your
camcorder after charging the pre-installed
rechargeable battery.
However, even if the pre-installed
rechargeable battery is not charged, the
camcorder operation will not be affected as
long as you are not recording the date.
x Procedures
Connect your camcorder to a wall outlet
using the supplied AC Adaptor, and leave it
with the POWER switch set to OFF (CHG)
for more than 24 hours.