Sony DCR-IP1 Camcorder User Manual


 
Getting started
Getting started
13
Step 2: Charging the
battery pack
You can charge the battery by attaching the
“InfoLITHIUM” battery pack (F series) to
your camcorder.
b Notes
You cannot use batteries other than the
“InfoLITHIUM” battery pack (F series) (p. 99).
Do not short-circuit the DC plug of the AC Adaptor
with any metallic objects. This may cause a
malfunction.
Use a nearby wall outlet when using the AC
Adaptor. Disconnect the AC Adaptor from the wall
outlet immediately if any malfunction occurs.
1 Slide the BATT (battery release)
lever in the direction of the arrow as
shown in the following illustration and
remove the battery terminal cover.
2 Attach the battery pack with its
terminal side facing your camcorder as
shown in the following illustration and
press down the battery pack until it
clicks.
3 With the v mark on the DC plug
facing up, connect the AC Adaptor to
the DC IN jack on the Handycam
Station.
4 Connect the power cord to the AC
Adaptor.
5 Connect the power cord to the wall
outlet.
6 Insert your camcorder into the
Handycam Station.
7 Set the POWER switch to (CHG)OFF.
To the wall outlet
DC IN jack
AC Adaptor
Handycam Station
DC plug
Power cord
BATT (battery
release) lever
DC IN jack
v mark
,continued