Filter
Top Products
7(E)
Rear view
Rear view of the DFR-E3000
1 CAMERA OUT connector
2 REFERENCE connectors and 75Ω termination switch
3 VIDEO SYNC OUT connector
4 CAMERA SYNC connector
5 PC I/F (IEEE 1284) connector
6 CAMERA IN connector
7 DFP-D3000 I/F connector
8 REMOTE I/O connector
9 AC IN connector
q; U (ground) connector
qa SDIF-2 IN connector
qs ANALOG OUT connector
qd WORD SYNC connector
qf ANALOG IN connector
qg TIME CODE connector
qh AES/EBU IN connector
1 CAMERA OUT connector
Connect to the DFR-C3000 for recording.
2 REFERENCE connectors and 75Ω termination
switch
Input video reference signal. Set the 75Ω termination
switch to OFF if you are using a loop-through
connection; set it to ON if you are not using a loop-
through connection.
3 VIDEO SYNC OUT connector
Outputs sync signal to external equipment. The type
of the output sync signal can be selected using the
computer connected to the PC I/F connector (NTSC,
MONO, or PAL). For details, contact your nearest
Sony dealer or service personnel.
4 CAMERA SYNC connector
Connect to the Westrex Camera System to output sync
signal. For details, contact your nearest Sony dealer or
service personnel.
5 PC I/F (IEEE 1284) connector
Connect to the IBM PC or compatible personal
computer for controlling the system. For details,
contact your nearest Sony dealer or service personnel.
6 CAMERA IN connector
Connect to the DFR-C3000 to input the sync signal.
7 DFP-D3000 I/F connector
Connect to the DFP-D3000 for monitoring the
recording.
U
- AC IN