Filter
Top Products
Balance function.
Daylight (White as Standard)
Cloudy (Bluish)
Fluorescent (Green-tinged)
Incandescent (Reddish)
To capture a basic white color in [Custom Setup] mode
1. Fn (White Balance) [Custom Setup]
2. Hold the camera so that the white area fully covers the AF area located in the center, and then
press the shutter button down.
The calibrated values (Color Temperature and Color filter) are displayed.
3. Select a register number using
/ on the control wheel, then press .
The monitor returns to the recording information display while retaining the memorized custom white
balance setting.
The custom white balance setting registered using this operation is effective until a new setting
is registered.
Notes
The message “Custom WB Error” indicates that the value is beyond the expected range. (For
example, when the flash is used on a subject in close proximity or when a brightly colored subject is
in the frame.) If you register this value, the
indicator turns yellow on the recording information
display. You can shoot at this point, but it is recommended that you set the white balance again to
obtain a more accurate white balance value.
Do not shake or strike the camera while capturing the basic white color.
If the flash is used when the shutter button is pressed, a custom white balance is registered with the
flash light taken into account. Take pictures with the flash in later shootings.
85