Filter
Top Products
87
Troubleshooting
Other
You have formatted a
“Memory Stick” by mistake.
• All the images on the “Memory Stick” are
deleted by formatting and cannot be
restored.
—
Symptom Cause Solution
Symptom Cause Solution
Your camera does not work.
• The battery level is low. (The E
indicator appears.)
• The USB cable is connected.
• The built-in microcomputer is not
working properly.
p Charge the batteries (page 12).
p Disconnect the USB cable, or operate on your
computer.
p Turn the power off and then on after one
minute, and check that the camera works
properly.
The power is on, but the
camera does not work.
• The built-in microcomputer is not
working properly.
p Remove the batteries, then install them again
after about one minute and turn on the camera.
If the functions still do not work, press the
RESET button located on the bottom of the
camera using a fine-tipped object, then turn the
power on again (page 81). (If you press the
RESET button, all settings including the date
and time are cleared.)
You cannot identify an
indicator on the LCD screen.
— p Check the indicator (pages 99 to 101).
The lens gets fogged.
• Moisture condensation has occurred. pTurn off the camera and leave for about an
hour at the room temperature for the moisture
to evaporate before use (page 94).