Filter
Top Products
Table of
contents
Operation
Search
MENU/Settings
Search
Index
83
GB
The remaining charge indicator is incorrect.
• This phenomenon occurs when you use the camera in an extremely hot or cold location.
• A discrepancy arose between the remaining charge indicator and the actual remaining battery charge.
Fully discharge the battery pack once, then charge it to correct the indication.
• Battery capacity decreases over time and through repeated use. When the operating time per charge
decreases markedly, the battery pack needs to be replaced (page 95). Purchase a new battery pack.
Cannot charge the battery pack.
• You cannot charge the battery pack using the AC Adaptor. Use the battery charger to charge the
battery.
The CHARGE lamp flashes while charging the battery.
• Remove and reinsert the battery pack, making sure it is installed correctly.
• The temperature may be inappropriate for charging. Try charging the battery pack again within the
proper charging temperature range (10°C to 30°C (50°F to 86°F)).
• Refer to page 96 for details.
Cannot record images.
• When images cannot be recorded into a memory card but are recorded into the internal memory, even
though a memory card has been inserted into the camera, make sure that the memory card has been
fully inserted.
• Check the free capacity of the internal memory or the memory card. If it is full, do one of the
following:
– Delete unnecessary images (page 26).
– Change the memory card.
• You cannot record images while charging the flash.
• When recording movies, it is recommended that you use the following memory cards:
– “Memory Stick PRO Duo” media, “Memory Stick PRO-HG Duo” media
– SD memory card or SDHC memory card (Class 2 or faster)
• Set the mode switch to (Still Image) when shooting still images.
• Set the mode switch to (Movie) when shooting movies.
Smile Shutter function does not work.
• No image is shot if a smiling face is not detected.
Anti-blur function does not work.
• The anti-blur function does not work when appears on the display.
• The anti-blur function may not work properly when shooting night scenes.
• Shoot after pressing the shutter button halfway down.
The image is out of focus.
• The subject is too close. When shooting, make sure to position the lens farther away from the subject
than the shortest shooting distance (approximately 5 cm (2 inches) (W)/50 cm (1 ft 7 3/4 inches) (T)
from the lens).
• (Twilight) or (Landscape) mode is selected in the Scene Selection when shooting still images.
Shooting still images/movies