Filter
Top Products
10
EN
Basic Operations
1 Press the POWER button.
The camera will be turned on, performing the
pan/tilt reset action automatically.
2 Press the arrow button to perform the
pan/tilt operation.
While checking the picture on the screen,
press a desired arrow button.
To move the camera inch by inch, press
the button for a moment.
To move the camera in a wide range,
press and hold down the button.
To move the camera diagonally, press
the arrow button ( or ) while holding
down the arrow button ( or ).
To face the camera back to the front
Press the HOME button.
If you accidentally move the camera
with your hand
Press the PAN-TILT RESET button to reset the
pan/tilt position.
The deviation from the position that the camera
memorizes will be corrected and the operation will
be back in order.
If you wish to face the camera toward
the opposite direction in which the
arrow on a pressed button points
The camera is preset to face toward the right
whenever the arrow ( ) button is pressed. You
might wish to face the camera toward the opposite
direction in which the arrow on a pressed button
points, in such a case when you change the
direction of the camera while checking the picture
on the screen. In this case, press the REV button
while holding down the L/R DIRECTION SET
button.
To reset that setting, press the STD button while
holding down the L/R DIRECTION SET button.
Pan/Tilt Operation
1
2
STD
REV
HOME
PAN-TILT
RESET
L/R DIRECTION
SET
1
AUTO
2
3
CAMERA SELECT
ON/OFFFAR ENTRYOFFSET
FOCUS
POWER
BACK LIGHT
CHASE
AT
MD
NEAR
MENU
HOME
CURSOR
L/R
DIRECTION SET
PAN-TILT
RESET
AUTO ZOOM
AE
ON/OFF
MANUAL
DETECTFRAME
PRESET
RESET
POSITION
PAN-TILT/CURSOR
SLOW·
ZOOM·
FAST
TT
WW
DATA SCREEN
STD REV
123
456
START/STOP FRAME DISPLAY
CAMERA SELECT
Arrow
button
SettingMovement of
the camera
While holding
down
L/R
DIRECTION SET
STD
1
Press
While holding
down
L/R
DIRECTION SET
Press
REV
2
Note
Repeat the above-mentioned procedure for each remote
commander if you are using more than one remote
commander. This is because the setting is performed by
changing the signal emitted from each remote commander,
not by changing the setting of the camera itself.
If the lamp at the side of the lens
flashes red
The micro computer inside the camera might not
memorize the current pan/tilt position properly.
Press the PAN-TILT RESET button to reset the
pan/tilt position.
Flashes.