Filter
Top Products
19
EN
5 Repeat pressing the DETECT button to
select a frame to be used.
Each time that button is pressed, the frame to
be used is cyclically changed as follows:
FRAME 1 FRAME 2 F1 & F2*
* If a change is detected even in either of FRAME 1
or FRAME 2, the lamp at the side of the lens lights
up red.
6 Press the START/STOP button to
activate the MD function.
To turn off the setting value and/or
frame
If the setting value and/or frame are displayed as
you record a picture, those come with the recorded
picture.
To turn off the setting value, press the DATA
SCREEN button.
To turn off the frame, press the FRAME
DISPLAY button.
To cancel the MD function
Press the START/STOP button.
To exit from the MD mode, press the MD ON/
OFF button.
Note
Once the frame is set, it remains memorized until the
power is turned off.
To retain the memory of the frame setting even if the power
is turned off, set the BACKUP switch, at the rear of the
camera head, to ON. (See “About backup” on page 25.)
2 Press the FRAME button to enter into the
detection frame setting mode.
3 Decide the position and size of the
FRAME 1.
q Press the arrow button to set the position
of the FRAME 1. Then press the FRAME
button.
w Press the arrow button to set the size of the
FRAME 1. Then press the FRAME
button.
That completes the settings of the FRAME 1’s
position and size, and enter into the setting
mode of the FRAME 2.
If you choose not to set the FRAME 2,
proceed with the step 5.
4 Repeat the procedure of the step 3 to set
the FRAME 2’s position and size.
continue to next page
FRAME 1
MD MODE FRAME DRIVE
SET FRAME
FRAME 1
MD MODE FRAME DRIVE
SET FRAME
FRAME 1
MD MODE FRAME DRIVE
SET FRAME
FRAME 1
MD MODE
WORKING NOW
F1&F2
MD MODE FRAME DRIVE
SET FRAME