Filter
Top Products
75
Customizing your camcorder
GENERAL SET
(Other setup items)
Touch 1, then 2.
If the item is not on the screen, touch v/V
to change the page.
How to set
(HOME MENU) t page 61
(OPTION MENU) t page 76
The default settings are marked with B.
The default setting is [ON], allowing you to
view the demonstration in about 10
minutes, after you slide the POWER switch
to (Movie).
z Tips
• The demonstration will be suspended in
situations such as those described below.
– When you press START/STOP or PHOTO.
– When you touch the screen during the
demonstration (The demonstration starts
again after about 10 minutes).
– When you remove or insert a “Memory Stick
Duo.”
– When you set the POWER switch to
(Still).
– When you press (HOME) or (VIEW
IMAGES).
The camera recording lamp on the front of
your camcorder lights up, as the default
setting is [ON].
See page 103.
DEMO MODE
REC LAMP (Recording
lamp)
CALIBRATION
B5 min
The camcorder is automatically turned off
when you do not operate your camcorder
for more than approximately 5 minutes.
NEVER
The camcorder is not automatically turned
off.
b Notes
• When you connect your camcorder to a wall
outlet, [A.SHUT OFF] is automatically set to
[NEVER].
The default setting is [ON], allowing you to
use the supplied Remote Commander
(p. 111).
z Tips
• Set to [OFF] to prevent your camcorder from
responding to a command sent by another VCR
remote control unit.
When the drop sensor has detected that the
camcorder has been dropped, your
camcorder may not allow you to record and
play back correctly to protect the internal
hard disk, as the default setting is [ON].
When dropping is detected, appears.
b Notes
• Set the drop sensor to [ON] when you use the
camcorder. Otherwise, if you drop the
camcorder, you may damage the internal hard
disk.
• In a non-gravity situation, the drop sensor
activates. When you record images during an
activity such as roller-coasting or skydiving,
you can set [DROP SENSOR] to [OFF] ( )
so as not to activate the drop sensor.
A.SHUT OFF (Auto shut
off)
REMOTE CTRL (Remote
control)
DROP SENSOR