Filter
Top Products
94
US
cannot make new recording during this
period.
The recording media is full. Delete
unn
ecessary images (p. 44).
Total number of movie scenes or photos
exceeds the recordable capacity of your
c
amcorder (p. 104, 105). Delete unnecessary
im
ages (p. 44).
W
hile [DROP SENSOR] is activated (p. 90),
you may not record images. (HDR-XR550/
XR550V)
The temperature of your camcorder is
extremely high. Turn off your camcorder and
leave it for a while in a cool place.
The temperature of your camcorder is
extremely low. Turn off your camcorder and
take it to a warm place. Leave the camcorder
there for a while, then turn on the camcorder.
Photos cannot be recorded.
You cannot record photos together with:
[ FADER]
[GOLF SHOT]
[SMTH SLW REC]
When [ REC MODE] is set to [HD FX], you
cannot record photos while recording movies.
The access lamp remains lit or flashing
even if recording was stopped.
Your camcorder is recording the scene you
have just shot on the memory card.
The imaging field looks different.
The imaging field may look different
depending on the condition of your
camcorder. This is not a malfunction.
The flash does not work.
You cannot record with the built-in flash
while:
the (movie) lamp is on
[CONVERSION LENS] is set to other than
[OFF]
Even if auto flash or (Auto redeye
reduction) is selected, you cannot use the
flash with:
NightShot
[IRIS] or [SHUTTER SPEED] that is assigned
to the MANUAL dial
[SPOT MTR/FCS]
[SPOT METER]
[MANUAL] in [EXPOSURE]
[TWILIGHT], [SUNRISE&SUNSET],
[FIREWORKS], [LANDSCAPE],
[SPOTLIGHT], [BEACH] or [SNOW] in
[SCENE SELECTION]
The actual recording time for movies is
less than the expected recording time of
the recording media.
Depending on the recording conditions, the
time available for recording may be shorter, for
example when recording a fast moving object,
et
c. (p. 104).
The camcorder stops operating.
The temperature of your camcorder is
extremely high. Turn off your camcorder and
leave it for a while in a cool place.
The temperature of your camcorder is
extremely low. Turn off your camcorder and
take it to a warm place. Leave the camcorder
there for a while, then turn on the camcorder.
If you keep applying vibration on the
camcorder, recording may stop.
There is a time difference between the
point when START/STOP is pressed and
the point that the recording movie is
started or stopped actually.
On your camcorder, there may be a slight
time difference between the point where you
press START/STOP and the actual point that
recording movie starts/stops. This is not a
malfunction.