Filter
Top Products
3
Chapter 3 Recording and Playback3-48
• When the LIGHT switch is set to MANUAL and the switch of the
light is set to ON, the light is always on.
7 Push the MENU knob.
The ? mark at the left of setting changes to a z mark and the z
mark at the left of PRE-LIGHTING changes to a t mark.
8 To end the menu operation, set the MENU ON/OFF switch to OFF
or close the cover of the menu operating section.
The menu disappears from the viewfinder screen and the message
“INTERVAL *SEC *FRAME”, indicating the continuous trigger
mode of the Manual Interval Rec mode, appears along the bottom of
the viewfinder.
*SEC indicates the trigger interval preset and *FRAME indicates
the number of frames preset.
The display indicating the current status of the camcorder appears
along the top and bottom of the viewfinder.
Note
The settings for the continuos trigger mode of the Manual Interval Rec
mode are maintained until changed. However, if you switch the
camcorder power off, Manual Interval Rec mode settings are cleared
except for the NUMBER OF FRAME, INTERVAL TIME, and PRE-
LIGHTING settings. To use the continuous trigger mode of the Manual
Interval Rec function again after switching on the power, perform steps 1
to 2 in “Setting the single trigger mode” on page 3-40.