Filter
Top Products
83
US
Others/Index
power of the camcorder is turned on, do not
close the LCD panel. The image data that has
been recorded may be lost.
Notes on optional accessories
We recommend using genuine Sony accessories.
Genuine Sony accessories may not be available
in some countries/regions.
Active Interface Shoe
The Active Interface Shoe supplies power to
accessories such as a video light, a flash, or a
microphone (sold separately). The accessory
can be turned on or off as you open or close
the LCD screen, and the viewfinder (HDR-
CX760V/PJ760/PJ760V) of your camcorder.
Refer to the operating instructions supplied
with your accessory for details.
The Active Interface Shoe has a safety device
for fixing the installed accessory securely. To
connect an accessory, press down and push it to
the end, and then tighten the screw. To remove
an accessory, loosen the screw, and then press
down and pull out the accessory.
When you are recording movies with an
external flash (sold separately) connected to
the accessory shoe, turn off the power of the
external flash to prevent charging noise being
recorded.
You cannot use an external flash (sold
separately) and the built-in flash at the same
time.
When an external microphone (sold separately)
is connected, it takes precedence over the built-
in microphone.
On Wireless Remote Commander
Remove the insulation sheet before using the
Wireless Remote Commander.
Point the Wireless Remote Commander
towards the remote sensor to operate your
camcorder (p. 13).
When no commands have been sent from the
Wireless Remote Commander within a certain
period, the light blue frame disappears. When
you press any of ///, or ENTER again,
the frame appears at the position where it was
displayed last.
You cannot select some buttons on the LCD
screen, or the viewfinder (HDR-CX760V/
PJ760/PJ760V) using ///.
To change the battery of the Wireless Remote
Commander
While pressing on the tab, inset your fingernail
into the slit to pull out the battery case.
Place a new battery with the + side facing up.
Insert the battery case back into the Wireless
Remote Commander until it clicks.
WARNING
Battery may explode if mistreated. Do not
recharge, disassemble or dispose of in fire.
When the lithium battery becomes weak, the
operating distance of the Wireless Remote
Commander may shorten, or the Wireless
Remote Commander may not function
properly. In this case, replace the battery with
a Sony CR2025 lithium battery. Use of another
battery may present a risk of fire or explosion.
LCD screen
Do not apply excessive pressure on the LCD
screen, as it may cause uneven color and other
damage.
Tab
Insulation sheet