Filter
Top Products
Administrating the Camera
Saving the Camera Position and Action — Preset position Menu
58
Saving the Camera
Position and Action
—
Preset position Menu
When you click in the Administrator menu,
the Preset position menu appears. Use this menu to save
camera’s pan, tilt and zoom positions and set tours
(programmed action of the camera).
The Preset position menu consists of 2 tabs: Position
and Tour.
Position Tab — Saving pan/tilt/
zoom position
You can set up to 16 camera positions (pan, tilt and zoom
positions).
Home position setting
Set the current camera position as the home position.
Set
Click to save the current pan, tilt and zoom positions as
the home position. To move the camera to the home
position, click in the control panel (page 21).
Reset
Click to reset the home position to the factory-set
position.
Preset
Configure and save preset positions.
No.
Select a preset number from 1 to 16 from the drop-down
list.
Name
Type the preset position name of the selected preset
number using up to 32 characters.
Set
Click to save the current camera position to the selected
preset number.
To save a preset position, operate as follows:
1
Move the camera to the position to be saved while
you are checking the image with the main viewer.
2
Select a preset number for saving, and type the
preset position name.
3
Click the Set button.
The camera position is saved.
Position at alarm
The camera can synchronize the preset position with
Sensor input 1 or 2 or with the object detection function.
If an alarm is detected by the sensor input or the object
detection function, the camera automatically moves to
the corresponding preset position.
If you do not want to synchronize with any preset
number, select none.
Sensor input 1 (S1)
Select a preset position to synchronize with the alarm
from Sensor input 1.
Sensor input 2 (S2)
Select a preset position to synchronize with the alarm
from Sensor input 2.
Object detection (OD)
Select a preset position to synchronize with the alarm
from the object detection.
Click Detection, and the Object detection menu is
displayed to allow you to set the object detection
function (page 77).
Note
In the case where the synchronized preset position is
specified, the alarm event that happens when the camera
moves to the preset position will be invalid.