Filter
Top Products
2
Owner's Record
The model and serial numbers are located on the bottom.
Record the serial number in the space provided below.
Refer to these numbers whenever you call upon your
Sony dealer regarding this product.
Model No. ____________________
Serial No. ____________________
To prevent fire or shock hazard, do not
expose the unit to rain or moisture.
To avoid electrical shock, do not open the
cabinet. Refer servicing to qualified
personnel only.
WARNING
This installation should be made by a qualified service
person and should conform to all local codes.
WARNING
A readily accessible disconnect device shall be
incorporated in the building installtion wiring.
WARNING (for Installers only)
Instructions for installing the equipment on the ceiling:
After the installtion, ensure the connection is capable of
supporting four times the weight of the rquipment
downwards.
CAUTION
The rating label is located on the bottom.
CAUTION for LAN port
For safety reason, do not connect the LAN port to any
network devices that might have excessive voltage.
Power Supply
Caution for U.S.A. and Canada
The SNC-RZ25N operates on 24V AC or 12V DC.
The SNC-RZ25N automatically detects the power.
Use a Class 2 power supply which is UL Listed (in the
U. S. A.) or CSA-certified (in Canada).
Caution for other countries
The SNC-RZ25P operates on 24V AC or 12V DC.
The SNC-RZ25P automatically detects the power.
Use a power supply rated 24 V AC or 12 V DC witch
meets the requirements for SELV (Safety Extra Low
Voltage) and complies with Limited Power Source
according to IEC 60950.
For customers in the U.S.A. (SNC-RZ25N
only)
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful
interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference wll not occur in a particular installation. If
this equipment does cause harmful interference to radio
or television reception, which can be determined by
turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the
following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and
receiver.
– Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
– Consult the dealer or an experienced radio/TV
technician for help.
You are cautioned that any changes or modifications not
expressly approved in this manual could void your
authority to operate this equipment.
The shielded interface cable recommended in this
manual must be used with this equipment in order to
comply with the limits for a digital device pursuant to
Subpart B of Part 15 of FCC Rules.
If you have any questions about this product, you may
call:
Sony’s Business Information Center (BIC) at 1-
800-686-SONY(7669)
or Write to: Sony Customer Information Services
Center
6900-29, Daniels Parkway, PMB 330
Fort Myers, Florida 33912
WARNING
Declaration of Conformity
Trade Name: SONY
Model No: SNC-RZ25N
Responsible Party: Sony Electronics Inc.
Address: 16450 W. Bernardo
Dr, san Diego, CA
92127 USA
Telephone No: 858-942-2230
This device complies with Part 15 of the
FCC Rules. Operation is subject to the
following two conditions: (1) This device
may not cause harmful interference, and (2)
this device must accept any interference
received, including interference that may
cause undesired operation.