Filter
Top Products
101
Troubleshooting
Smart zoom does not
function.
• [Digital Zoom] is set to [Precision]or [Off] in the
SET UP settings.
• The
image size is set to [5M] (DSC-P93), [4M]
(DSC-P73) or [3:2].
• You are shooting in Multi Burst mode.
• This function cannot be used when you shoot a
movie.
pSet [Digital Zoom] to [Smart] (pages 27, 47, 116).
pSet image size to other settings except [5M] (DSC-P93), [4M]
(DSC-P73) and [3:2] (pages 22, 27).
pThe smart zoom cannot be used in Multi Burst mode (pages 27,
61).
—
The image is too dark. • You are shooting a subject with a light source
behind the subject.
• The brightness of the LCD screen is too low.
pSelect the metering mode (page 57).
pAdjust the exposure (page 55).
pAdjust the brightness of the LCD backlight (pages 47, 117).
The image is too bright. • You are shooting a spot lighted subject in a dark
location such as on a stage.
• The brightness of the LCD screen is too high.
pAdjust the exposure (page 55).
pAdjust the brightness of the LCD backlight (pages 47, 117).
When looking at the LCD
screen in a dark place,
some noise may show up
on the LCD screen.
• The camera temporarily brightens the LCD
screen to allow you to check the image being
displayed while you are using the camera in a
dark place.
pThis will have no effect on the image you shoot.
The image is
monochrome (black and
white).
• [PFX] (P.Effect) is set to [B&W]. pCancel the mode (page 62).
Vertical streaks appear
when you are shooting a
very bright subject.
• The smear phenomenon is occurring. pThis is not a malfunction.
You cannot shoot in Burst
mode.
• The capacity of the “Memory Stick” is full.
• The camera can record only one image, since the
remaining battery level is insufficient.
pDelete unnecessary images (pages 42, 81).
pInstall charged batteries (page 11).
Symptom Cause Solution