Filter
Top Products
28
DCR-HC21 2-584-905-11(1)
Remote Commander
Remove the insulation sheet before using
the Remote Commander.
Insulation sheet
1
2
3
4
5
6
7
8
9
PHOTO* (p. 20)
The image displayed on the screen when you
press this button will be recorded as a still
image.
SEARCH M.*
*
Video control buttons (Rewind,
Playback, Fast-forward, Pause, Stop,
Slow) (p. 19, 21)
ZERO SET MEMORY*
Transmitter
REC START/STOP (p. 19, 20)
Power zoom (p. 18, 22)
DISPLAY (p. 15)
Press this button to hide the screen indicators.
* These buttons are not available during Easy
Handycam operation.
• Point the Remote Commander towards the
remote sensor to operate your camcorder (p.
23).
• To change the battery, see page 84.
Searching quickly for a desired
scene (Zero set memory)
1 During playback, press ZERO
SET MEMORY
at a point you
want to locate later on.
The tape counter is reset to “0:00:00”
and appears on the screen.
0:00:0060min
FN
If the tape counter is not displayed,
press DISPLAY
.
2 Press STOP
when you want to
stop playback.
3 Press REW
.
The tape stops automatically when the
tape counter reaches “0:00:00.”
4 Press PLAY
.
Playback starts from the point
designated “0:00:00” on the tape
counter.
• There may be a discrepancy of several seconds
between the time code and the tape counter.
• Zero set memory will not function correctly
if there is a blank section between recorded
sections on the tape.
To cancel the operation
Press ZERO SET MEMORY
again.