Filter
Top Products
masterpage:Right
filename[D:\nakano's\3061389111\3061389111MVCFD95UC\02GB-
MVCFD95UC\10add.fm]
Additional information
59
model name1[MVC-FD95]
[3-061-389-
11
(1)]
The flash does not work.
•
The flash is set to .
t
Set the flash to (no indication), , or
(page 19).
•
The camera is in one of the following PROGRAM
AE modes: Twilight, Twilight plus, or Landscape.
t
Cancel the PROGRAM AE function or set the
flash to (page 19, 40).
•
The PLAY/STILL/MOVIE selector is set to
MOVIE.
t
Set it to STILL.
•
The flash is not popped up.
t
Pop up the flash (page 19).
The read/write time is
slow when using a
“Memory Stick.”
•
When using the Floppy Disk Adaptor for Memory
Stick, writing and reading images take about twice
times than using a floppy disk.
t
This is not a malfunction.
The date and time are
recorded incorrectly.
•
The date and time are not set correctly.
t
Set the correct date and time (page 12).
Vertical streaks appear
when you are shooting a
very bright subject.
•
This is called the smear phenomenon.
t
This is not a malfunction.
The battery life is short.
•
You are recording/playing back images under
extremely cold temperatures.
•
The battery pack is not charged enough.
t
Charge the battery pack fully.
•
The battery pack is dead.
t
Replace the battery pack with a new one.
The indication of the
battery remaining time is
not proper.
•
You are using the camera for many hours under
extremely hot or cold temperatures.
•
The battery pack is dead.
t
Replace the battery pack with a new one
(page 8).
•
The battery level is too low.
t
Install the charged battery pack (page 8, 9).
The power is immediately
turned off even if the
battery remaining
indicator indicates that the
battery level is sufficient.
t
Charge the battery pack about one hour after the
normal charge is complete (page 9).
The zoom does not work.
•
PROGRAM AE is set to the Panfocus mode.
t
Cancel the Panfocus mode (page 40).
Symptom Cause and/or Solution
01cov.book Page 59 Thursday, March 9, 2000 10:26 AM