Filter
Top Products
masterpage:Right
filename[D:\nakano's\3061389111\3061389111MVCFD95UC\02GB-
MVCFD95UC\03pre.fm]
Getting started
9
model name1[MVC-FD95]
[3-061-389-
11
(1)]
Charging the battery pack
When the camera is turned on, you cannot charge the battery pack. Be sure to turn off
the power of the camera.
Battery remaining indicator
The LCD screen or finder on the camera shows the remaining time for which you can
still record or play back images.
This indication may not be entirely accurate depending on the conditions of use and
the operating environment.
Auto power-off function
If you do not operate the camera for about three minutes during recording, the camera
turns off automatically to prevent wearing down the battery pack. To use the camera
again, slide the POWER switch to the right to turn on the camera again.
1
Insert the battery pack into your camera.
2
Open the DC IN cover and connect the DC connecting plug to the
DC IN jack of your camera with the
v
mark facing up.
3
Connect the power cord (mains lead) to the AC power adaptor and
then to a wall outlet (mains).
The ON/CHG lamp (orange) below the LCD screen lights up when charging
begins. When the ON/CHG lamp goes off,
normal charge
is completed. For
full charge
, which allows you to use the battery longer than usual, leave the
battery pack inserted for about one hour after normal charge is completed.
1
2
3
AC-L10A/L10B/L10C
AC power adaptor
to DC IN jack
Power cord
(mains lead)
Battery pack
to DC IN jack
to wall outlet (mains)
01cov.book Page 9 Thursday, March 9, 2000 10:26 AM