Filter
Top Products
229
Troubleshooting
Others
Symptom Cause and/or Corrective Action
• Your VCR and/or video camera recorder is not set
correctly.
c Make sure the input selector of the VCR is set to LINE.
Also, make sure the power switch of the video camera is
set to VTR/VCR (p. 99).
• The IR SETUP code or PAUSE MODE is not set correctly.
c Select the correct IR SETUP code and PAUSE MODE,
according to your VCR. Then confirm VCR operation
with the IR TEST function (p. 99).
• The input selector on the VCR is not set correctly.
c Check the connection and set the input selector on the
VCR again (p. 107).
• Your camcorder is connected to DV equipment of other
than Sony using the i.LINK cable.
c Set it to IR (p. 107).
• You have attempted to set a program on a blank portion of
the tape.
c Set the program again on a recorded portion (p. 115).
• Your camcorder and the VCR are not synchronized.
c Adjust the synchronization (p. 113).
• The IR SETUP code is incorrect.
c Set the correct code (p. 101).
• PB MODE is set to / in the menu settings.*
3)
c Set it to AUTO (p. 215).
• Setting program on a blank portion of the tape is
attempted.
c Set the program again on a recorded portion (p. 156).
• COMMANDER is set to OFF in the menu settings.
c Set it to ON (p. 222).
• Something is blocking the infrared rays.
c Remove the obstacle.
• The batteries are inserted with + and – incorrectly
matching + and – inside the battery compartment.
c Insert the batteries correctly (p. 264).
• The batteries are dead.
c Insert new ones (p. 264).
Easy Dubbing does not function.*
1)
Digital program editing to a tape
does not function.*
2)
Digital program editing to a
“Memory Stick” does not function.*
3)
The Remote Commander supplied
with your camcorder does not
work.*
4)
Types of trouble and how to correct trouble
*
1)
*
2)
*
3)
*
4)
*
5)
(continued on the following page)