Speco Technologies DVR-16TN Camcorder User Manual


 
User’s Manual
DVR-4TN/8TN/16TN/16TS/16TT Series
SPECO TECHNOLOGIES 01/06
34
Press CALL key for 3 seconds, the BNC Monitor will be given the same
function as the VGA Monitor, except Playback and Search function. You can
use the BNC Monitor to take over the DVR-16TT unit at the same time, as if
the two monitors are connected to two individual DVR-16TT units.
When using this function, a small figure ( ) appears in the mid-button side
of the two monitors—the yellow one represents the monitor is now accessed.
NOTE: When the VGA monitor is now under Dome Control Mode’ or the OSD setup
mode, or hasn’t exit the OSD menu, the BNC monitor cannot access the OSD setup
menu.
4.2 Sequence Setup
This section introduce you how to view in sequence mode with both Main
Monitor and Call Monitor, if connected. Sequence function can avoid manually
backtracking and give more flexibility while surveillance.
4.2.1 Sequence on Main Monitor
The automatic sequence function can be used in any view mode. Select
certain view format and press SEQ to toggle the automatic sequential
sequence, press ESC to stop sequencing. The figure below displays the
4-camera sequencing view modes.
4.2.2 Call Monitor Control
Users can use the DVR-4TN/8TN/16TN/16TS/16TT series unit front panel to
control a call monitor display without having to access the Main menu. Two
viewing modes can be displayed on call monitor: Sequence display and
Single camera display. To program the call monitor sequence, see section 5.5
Sequence Setup.