Filter
Top Products
1-2
SUPERSERVER 6015B-3/6015B-T User's Manual
1-2 Serverboard Features
At the heart of the SuperServer 6015B-3/6015B-T lies the X7DBR-3/X7DBR-E, a
dual processor serverboard based on Intel's 5000P chipset. Below are the main
features of the X7DBR-3/X7DBR-E (see Figure 1-1 for a block diagram of the
chipset).
Processors
The X7DBR-3/X7DBR-E supports single or dual 771-pin Intel Xeon
5400/5300/5200/5100/5000 series processors at a FSB speed of 1333/1066/667
MHz. Please refer to the serverboard description pages on our web site for a
complete listing of supported processors.
Memory
The X7DBR-3/X7DBR-E has eight 240-pin DIMM sockets that can support up to
32 GB of ECC FBD (Fully Buffered DIMM) DDR2-667 or DDR2-533 SDRAM. The
memory is an interleaved confi guration, which requires modules of the same size
and speed to be installed in pairs. Please refer to Chapter 5 for memory speed
jumper settings.
Onboard SAS (6015B-3)
An onboard Adaptec AIC-9410 Serial Attached SCSI (SAS) controller in integrated
into the X7DBR-3, which supports eight SAS hard drives with SES2. The SAS drives
are connected to a backplane that provides power, bus termination and confi gura-
tion settings and are hot-swappable units. Note: The operating system you use
must have RAID support to enable the hot-swap capability and RAID function of
the SAS drives. RAID 0, 1, 5 and 10 are supported.
Serial ATA
An on-chip (ESB2) SATA controller is integrated into the X7DBR-E to provide a
six-port, 3 Gb/sec Serial ATA subsystem, which is RAID 0, 1 and 10 supported.
The SATA drives are hot-swappable units. Note: The operating system you use
SuperServer 6015B-3/6015B-T User's Manual
Note: the "V" and "B" at the end of a server name (e.g. 6015B-3V or 6015B-3B)
denotes the chassis color. V is for silver and B is for black.