Filter
Top Products
WebCAM user manual -18-
Chapter 4: Using Utility to Setup IP & Update Firmware
Fig.10. IP Configuration: WebCAM Advanced settings
i. Device Password
Use this to set an access password to the individual device. Once set, the
user must enter the password to access the device. In addition, the IP
Address will not be shown on the right display panel of Utility.
Utility will request for the “Input Device Password” when you click either “Setup
Wizard”, “Launch WebCAM” or “IP Configuration”
Devise
Password
enabled. IP
Address
hidden.
Devise
Password
not set.