Filter
Top Products
WebCAM user manual -28-
Chapter 5: Web Manager
“Pan Control”
Choose from “Normal” or “Reverse”. This is to set the mirror function of the
camera and fix the image the way the user desires each time the user logs on
to view.
“Tilt Control”
Choose from “Normal” or “Reverse”. This is to set the image to its right side up.
Similar to the “Pan Control” function.
Click “Apply” to save changes. Otherwise, all changes will be lost.
2.3.2 Network
This option determines the WebCAM Network settings.
i. IP Address
These items were all setup earlier in Setup Wizard. Enter new addresses and
click “Apply” to change.
Fig.19. WebCAM IP Address Settings
“IP Address”
This item determines WebCAM IP Address.
“Subnet Mask”
This item sets WebCAM Subnet Mask. The value is normally 255.255.255.0
“Gateway”
This item is to set WebCAM Gateway.
“Obtain an IP address”
This allows the user to choose either to set WebCAM IP Address manually or
via DHCP. WebCAM will reboot after the above settings have been changed.
ii. DNS Server IP
Fig.20. WebCAM IP DNS Server IP
“Primary DNS Server IP”
This item sets WebCAM primary DNS Server IP address.
“Secondary DNS Server IP”
This item sets WebCAM secondary DNS Server IP address. WebCAM will use
the secondary DNS Server IP address if the Primary DNS Server IP address is
not working.