Filter
Top Products
Introduction
Congratulations on your purchase of this Swann PTZ Camera!
This installation and setup guide will walk you through the basics of connecting the
PTZ camera to your DVR, and walk you through the settings on the DVR you’ll need
to use to control the camera.
Be aware that the camera must be connected to a compatible DVR to operate
correctly.
The included stand-alone RS485 controller will operate the basic features of the
camera, and access the on-screen display (OSD). You won’t be able to program the
camera properly or integrate it’s functions with your system unless your DVR is
configured to do so.
Compatibility
This Swann PTZ camera is compatible with most current Swann DVRs. We can
confirm that it will work with the following DVR models:
1200, 1300, 2500, 2550, 2600, 3000 and 4000 series DVRs.
This is not an exhaustive list - since the time of publication we may have released
newer DVRs with which this camera is compatible. Check your DVR documentation
to learn more. Any Swann DVR with an RS485 port should be compatible with this
camera.
IMPORTANT: If mounting the camera outside, be sure to properly seal all joints in
the mounting arm/bracket using a silicon sealant. If this is not fully sealed, water
can enter the dome causing malfunction or failure.
Package Contents
PRO-752 Camera
RS485 Controller
Camera Cable
Extension Cable
Screws and Mounting Hardware
Power Supply (not pictured)
Power Splitter (not pictured)