Filter
Top Products
Configuring your DVR
Camera No.: Channel1
Baud Rate: 9600
Data Bit: 8
Stop Bit: 1
Parity: None
Flow Ctrol: None
PTZ Protocol: Pelco-D
Address: 1
You can connect the camera to any input on the DVR. For
sake of ease, we suggest connecting it to channel 1. These
instructions assume you’re using a Swann DVR 3000 or
Swann DVR 4000.
If you’ve got a different DVR, then the location of the
connections may be different, but it works much the same way.
Configuring the DVR
Once you’ve got the PRO-
752 properly connected
to your DVR as shown and
have followed the basic
configuration procedures as
described in your DVR’s manual:
• Navigate to the PTZ menu:
Main Menu --> Device
--> PTZ
• If you’ve connected the
PRO-752 to channel 1 you
may not need to change
anything - we set the
default options to match
the requirements of the
PTZ cameras. Sometimes,
however, adjustments will
need to be made (varies by
DVR model).
• Check your DVR’s settings,
and change them as
necessary. Ensure that the
settings in this menu all
match these:
1
2