Filter
Top Products
15
5. Input Output Signal Specifications
HD/VD Output Amplitude Specifications
The amplitude level is the representative value
when terminated with 10kΩ. Output is enabled
when the rear panel HD/VD signal input/output
switch is set to the INT side.
4.5V
HD
VD
0V
4.5V
0V
VIDEO INDEX Output Specifications
The amplitude level is the representative value
when terminated with 10kΩ.
4.5V
0V
525H (Partial scanning OFF)
175H (Partial scanning ON)
VD Input Specifications
* Input impedance: 75Ω or 1kΩ or greater
* Input amplitude 2.0 to 5.0 Vp-p (75Ω termina-
tion ON or OFF)
* Voltage and pulse width were measured at
pin 7 of the 12-pin connector located on the
rear panel.
5H to 21H
2.0 to 5.0Vp-p
HD Input Specifications
* Input impedance: 75Ω or 10kΩ or greater
* Input amplitude 2.0 to 5.0 Vp-p (75Ω termina-
tion ON or OFF)
* Voltage and pulse width were measured at pin
6 of the 12-pin connector located on the rear
panel.
2.0 µs to 5.0 µs
2.0 5.0Vp-p
Trigger Pulse Specifications
* Input impedance: 10kΩ or greater
* Voltage and pulse width were measured at
pin 11 of the 12-pin connector located on the
rear panel.
More than 2µs
More than 2µs
PART Input Specifications
H: 2.0 to 5.0 V
L: 0 to 0.4 V