Filter
Top Products
121212
Hardware Installation
Notes:
l
The attached screws and anchors are used to install the camera to a solid surface.
(e.g. concrete) If installing to loose or thin material surfaces , use the appropriate
anchors (not included) with the screws.
l
Install the camera tightly.
Operating environment
–30 °C ~ +50 °C {–22 °F ~ 122 °F}
When the camera is installed and operated in low temperatures below –10 °C {14 °F},
normal images may not be obtained immediately after startup. In such a case, wait until
the camera warms up (taking more than 1 hour) and start adjustment after turning on
the power again.
Mounting the camera to a solid surface
1. Attach the alignment sticker to the wall. Drill three pilot holes (Φ 9.5mm x 40mm(D) (Φ
0.37inch x 1.57inch(D) )) and one big hole through the four circles on the sticker.
Then hammer the supplied plastic anchors into the holes and secure the plate with
supplied screws.
2. Fix the supplied bracket to the side of the Network Camera with two screws.
3. Feed the RJ45 cable through the front opening of the wall mount bracket. (If you
want to use external devices such as sensors and alarms, please refer to the
assembling steps on page 14.)
4. Push the spring bolt and hook the bracket onto the groove of the wall mount bracket.
5. Secure the two screws on the other side of the wall mount bracket.
6. Hang the wall mount bracket on the plate.
7. Fix the wall mount bracket with the supplied screw and spring washer.
8. Loosen the screw A and B with supplied wrench, and adjust the angle of the wall
mount bracket to aim at the shooting area. Then, secure the screw A and B with
supplied wrench.
9. Attach rubber pad on the screw A.