Filter
Top Products
29944AG 35
NETWORK SETUP
Network Setup allows the user to adjust settings such as Ports, set up emergency PPP information for use with the Emergency Agent
and enable Remote Access.
View IP Address Displays the IP address of the recorder.
Transport Rate Throttles the bandwidth on the recorder. This option is based on percentages of images sent.
Resolution By setting the resolution low, the images will be sent faster, however, the image quality will be
reduced considerably. When set to Original, full quality video will be sent [720 x 480 (NTSC) 720 x
576 (PAL)]. The Original setting is very bandwidth intensive.
Time Out Value When attempting to connect to the recorder, if the connection does not succeed during the timeout
period (seconds), the connection will be terminated.
Emergency Port Used to connect to the Alarm Monitor software.
Center Port Used to connect to the Surveillix remote software. This port must be specified in the Remote
Software to connect to the recorder.
Note Center Port 1025 is not available for remote connections. It is used by the ATI VGA management suite
Image Port Used to transfer the video to the Surveillix remote software.
Search Port Used to transfer search information to the Surveillix remote software.
Note If connecting to the recorder through a firewall, the above ports must be open to incoming and outgoing traffic.
Health Check Port Select to enable SCS to receive information regarding the health of the recorder.
Keyboard Control Select the Use Keyboard Control check box to enable use of a connected RS-232 PTZ
Joystick/Keyboard
Two Way Audio
Communication
Select the Enable Audio Communication check box
to enable two-way audio between the DVR and SCS
using a microphone connected to the DVR
Use with Emergency Agent
Settings for Video Sent to Remote Client
Use with Remote
Connections