Filter
Top Products
29944AG 43
Alarm Event
Configure the Alarm Event tab to send an email to all users set up to
receive Alarm Event emails when a Motion, Sensor, or No Signal event
occurs. These emails are also used when My Surveillix tab is configured.
1. Setup the General and Users tabs first.
(see above)
2. Select the Use Email Alarm check box.
3. Define the number of minutes between recording data checks.
4. Select Motion and/or Sensor to send and alert on that type of
event.
5. Click Apply.
MySurveillix
Configure the MySurveillix tab to enable the recorder for use with the
MySurveillix remote health monitoring
1. Setup the General and Users tabs first.
(see above)
2. Select the Use MySurveillix check box.
3. Define the interval to send e-mail messages in the Send Time box.
4. Enter a new numeric Security Code to protect against unauthorized
users and write it down.
5. Select the Send notifications to MySurveillix on alarm events
check box to enable sensor event notification.
6. Click Apply.
7. Click Close to return to the Administration tab.