Filter
Top Products
IP Setup is unable to detect my camera. What should I do?
1. Verify that you have followed all the steps in the Section Hardware Installation.
2. Disable any software firewall programs such as ZoneAlarm or Norton Internet Security. If
you are using Windows XP or Windows Vista, disable the built in firewall.
3. Click on Search in the IPSetup setup wizard.
The Image is blurry. How can I adjust the focus on the IP Camera?
You can adjust the IP Camera's focus by rotating the lens.
I do not have a DHCP server or DHCP is disabled on my network and I am unable to
configure the TV-IP252P. What should I do?
Go to the TCP/IP settings on your computer and assign a static IP address on your
computer's network adapter in the subnet of 192.168.10.x. Since the default IP address of
the TV-IP252P is 192.168.10.30, do not assign a static IP address of 192.168.10.30 on
your computer's network adapter. Open Internet Explorer and enter http://192.168.10.30
into the address bar. See the instructions below:
Troubleshooting
Windows Vista
Windows XP/2000
1. Go into the Control Panel, click Network and
Internet, click Network and Sharing Center,
click Manage Network Connections and
then right-click the Local Area Connection
icon and then click Properties.
2. Click Internet Protocol Version 4 (TCP/IPv4)
and then click Properties. Then click on Use
the following IP address, and make sure you
assign your network adapter an IP address in
the subnet of 192.168.10.x.
9
1. Go into the Control Panel, double-click the
Network Connections icon and then right-
click the Local Area Connection icon and
then click Properties.