Filter
Top Products
Programming
Before the
BC
860
XLT
can scan, you must program a frequency into at least one channel.
Repeat this procedure for each channel you program.
1.
Select the frequency.
2.
Enter MANUAL mode.
3.
Select the channel.
➪➪
4. Enter the frequency. To clear a mistake while entering
the frequency, press
.
twice,
and start over.
If the entered frequency is outside the
Frequency Range of the scanner,
(See Table on page 3, and the
Technical Specifications at the back of
this Guide), a distinctive beep sounds.
Press
.
and go back to Step 4.
11