Filter
Top Products
Care and Maintenance
General Use
Turn the scanner off before disconnecting the power.
Always write down the programmed frequencies in the event of
memory loss.
If memory is lost, simply reprogram each channel.
The display shows
000.0000
in all channels when there
has been a memory loss.
Always press each keypad button firmly until you hear the entry
tone for that key entry.
Location
If strong interference or electrical noise is received, relocate the
scanner or its antenna away from the source of the noise.
If possible, a higher elevation, may provide better reception.
Also try changing the height or angle of the antenna.
Do not use the scanner in high-moisture environments such as
the kitchen or bathroom.
Avoid placing the unit in direct sunlight or near heating elements
or vents.
Do not plug the scanner into an outlet controlled by a wall switch as
prolonged periods without power will cause scanner memory loss.
Cleaning
Disconnect the power to the unit before cleaning.
Clean the outside of the scanner with a mild detergent.
To prevent scratches,
do not
use abrasive cleaners or solvents.
Be careful not to rub the LCD Display window.
Do not use excessive amounts of water.
33