Filter
Top Products
40 VISIONEER MX 230 DIGITAL CAMERA USER’S GUIDE
CONNECT TO YOUR COMPUTER THE FIRST TIME
The first time you connect your camera to your computer, the
computer recognizes the camera as a new piece of hardware and
leads you through the installation. This is a one-time procedure.
To install your camera to copy photos and video clips:
1. Connect the small connector of the USB cable to the USB
port on the camera. See “Back View” on page 6 for the
position of the USB port on the camera.
2. Connect the large end of the USB cable to an empty USB slot
on your computer. To locate a USB slot, look for the USB icon
next to the connection slot.
3. Set the camera’s Mode dial to any mode except PC.
4. Turn on the camera.
5. Your computer detects the connection to the camera and
initiates installation of the new hardware.
■ Depending on the Windows operating system installed on
your computer, the installation may proceed automatically,
or you may be asked to follow the instructions in a new
hardware installation wizard.