Filter
Top Products
VIVOTEK
User's Manual - 97
Transparent HTTP Tunnel: If you want to use your own RS-485 device, you can use UART
commands to build a Transparent HTTP Tunnel. The UART commands will be sent through HTTP
tunnel established between the RS-485 device and the camera. For detailed application notes,
please refer to URL Commands started on page 115 or
http://www.vivotek.com/downloadles/support/
appnote/14_document_1.pdf
.
Preset Positions
If you select DynaDome/SmartDOME, Lilin PIH-7x00, Pelco D, Pelco P, or Samsung Scc643
protocol, as the PTZ driver and click the Save button, the Preset Position button will become
available. Click on the Preset Position button to open the configuration window. A total of 20
preset positions can be congured.
Please follow the steps below to congure preset positions:
1. Adjust the shooting area to the desired position using the buttons on the right side of the window.
2. Enter a name for the preset position, which allows for up to forty characters. Click Add to enable
the settings. The preset positions will be displayed under the Preset Location list on the left-hand
side.
3. To add additional preset positions, please repeat steps 1~2.
4. To remove a preset position from the list, select it from the drop-down list and click Remove.
5. The preset positions will also be displayed on the main page. Please refer to the illustration on
the next page.
6. Click Save to enable the settings.
Functions are the same as
the Control Panel on the
home page
1
4
6
2