Filter
Top Products
VIVOTEK
User's Manual - 7
Pin Name
+ Digital Input +
- Digital Input -
General I/O Terminal Block
This Network Camera provides a general I/O terminal block which is used to connect
external input / output devices. The pin denitions are described below. The 24V AC can
be used as an alternate power source.
Hardware Reset
The reset button is used to reset the system or restore the factory default settings.
Sometimes resetting the system can return the camera to normal operation. If the system
problems remain after reset, restore the factory settings and install again.
Reset: Press and release the recessed reset button with a straightened paper clip. Wait for
the Network Camera to reboot.
Restore: Press and hold the recessed reset button until the status LED rapidly blinks. Note
that all settings will be restored to factory default. Upon successful restore, the status LED
will blink green and red during normal operation.
Micro SD/SDHC/SDXC Card Capacity
This network camera is compliant with Micro SD/SDHC/SDXC 16GB / 8GB and other
preceding standard SD cards.