Filter
Top Products
VIVOTEK
50 - User's Manual
Please follow the steps below to setup a prole:
1. Check Enable this prole.
2. Select the applied mode: Day mode, Night mode,
or Schedule mode. Please manually enter a range
of time if you choose the Schedule mode.
3. Congure Exposure control settings in the folowing
columns. Please refer to previous dicussions for
detailed information.
4. Click Save to enable the setting and click Close to
exit the page.
You can click Restore to recall the original settings without incorporating the changes. When
completed with the settings on this page, click Save to enable the settings.
If you want to congure another sensor setting for day/night/schedule mode, please click Prole to
open the Prole of exposure settings page as shown below.
Activated period:
Select the mode this prole to apply to the Schedule mode. Please manually enter
a range of time if you choose Schedule mode. Then check Save to take effect.
■ Exposure time
: The Exposure time allows tuning for more or less light to enter the lens. The
congurable value ranges from 1/32000 to 1/5 of a second. An optimum shutter speed should be
maintained as long as the light level of the scene permits.
■
Gain control: Tune the slider bar to set the Gain Control to the best image quality. Higher gain
control value will generate a certain amount of noise, and that the gain control, lighting levels,
and picture performance are closely related.
Note that you can split the round pointers on the Exposure time and Gain control slide bars
into two halves and drag them on the bars to designate a range of values in which rmware can
automatically adapt to. Firmware will then automatically tune the Gain, Exposure time, and Iris
opening within the ranges you specied.