Filter
Top Products
www.vivotek.com
T: 886-2-82455282
F: 886-2-82455532
Installation
Hardware Installation
Please verify that your product
package contains all the accessories
listed in the foregoing Package
Contents. Depending on the user’s
application, an Ethernet cable may be
needed. The Ethernet cable should
meet the specs of UTP Category 5 and
not exceed 100 meters in length.
Connect the power adapter jack to
the Network Camera before plugging in
to the power socket. This will reduce
the risk of accidental electric shock.
Upon powering up, the device runs through a self-test procedure and the front LEDs
will blink between green and red for a few times. If self-test passes, the LEDs will shut
off and the Network Camera will be on stand-by and ready for software installation. If
self-test fails the red LED will blink several times. Refer to Appendix A for
troubleshooting.
The Network Camera will first detect Ethernet. If it does not connect to Ethernet, the
Network Camera will try WLAN. During the searching and connecting process to the
wireless access point or station, the LED of the Network Camera will keep red. Until
the Network Camera is connected to the other wireless device, the LED will become
green and flash. Operating in either network mode, the green LED will flash every
second as heartbeat to indicate alive.