Filter
Top Products
13
O P E R ATION (CONTINUED)
Turn the camera on as described
on page 8. Press the
Mode/Power button eight times to
select the Frequency mode; “60”
or “50” will appear in the display.
1
Within 3 seconds, press the
Shutter/Select button to select
the Frequency mode as shown
on the display i.e. if 60 appears,
press the Shutter/Select button
to change the setting to 60.
2
SETTING THE FREQUENCY MODE
Because the electrical power frequency is either 50Hz or 60Hz,
depending on the country you are located in, please set it according
to the country that you are located in. If located in USA, set to 60Hz.
To restore the camera to the
factory defaults, press the
R E S E T button (inside
compartment) using a pin or
similar item.
1
RESET BUTTON
DISPLAY
The display can only display two
digits. Although the capacity for
pictures in Lo(w) Resolution is
100, the display will show 99 until
two pictures have been taken
and then change to 98.
RESET BUTTON NOTE: When
you press the RESET button, all
the taken photos in the camera
will be deleted.
DDC9000P.qxp 7/15/05 10:40 AM Page 13