xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch
86
gigabit ports can be configured as uplink ports.
Access Ports
Access ports are for connecting VLANs setup on the Switch to the customer VLANs. Gigabit
ports cannot be configured as access ports.
Unknown Ports
This field displays the ports which have an unknown status.
The user may edit configurations for a Double VLAN by clicking its corresponding button, which will display the following
window:
Figure 7- 12. Double VLAN Configuration window
The parameters shown in the window above are explained below:
Parameter Description
VLAN Name
The name of the VLAN on the Switch.
Operation
Allows you to select Add Ports, Delete Ports or Config TPID.
Port Type
Allows the user to choose the type of port being utilized by the Service Provider VLAN. The user
may choose:
Access - Access ports are for connecting Switch VLANs to customer VLANs. Gigabit ports
cannot be configured as access ports.
Uplink - Uplink ports are for connecting Switch VLANs to the Provider VLANs on a remote
source. Only gigabit ports can be configured as uplink ports.
Port List
Use the From and To fields to set a list of ports to be placed in, or removed from, the Service
Provider VLAN.
TPID
The tagged protocol ID of the corresponding VLAN that will be used in identification of this
potential Double VLAN, written in hex form.
To create a Double VLAN, click the Add button, revealing the following window for the user to configure.
Figure 7- 13. Double VLAN Creation
To create a Double VLAN, enter the following parameters and click Apply.
Parameter Description
VLAN Name
Enter the pre-configured VLAN name to create as a Double VLAN.
