Model D2424 Reference Manual (Saving and Loading Song Data)
91
75Ω
WORD
OUTPUTINPUT
OUTPUT
DATA
16 - 9
24 - 17
8 - 1
100Ω
RS422
THRU
AC-IN
INPUT
16 - 9
24 - 17
8 - 1
SCSI
ONOFF
REMOTE
MIDI
INPUT
THRU
OUTPUT
1
2
34
5678
1
234
13141516
5
6
7
8
1718
19
20
9
10
11
12
21
22
2324
NE PAS OUVRIR
CAUTION
AVIS:
RISQUE DE CHOC ELECTRIQUE
WARNING:
TO REDUCE THE RISK OF FIRE OR ELECTRIC
SHOCK, DO NOT EXPOSE THIS EQUIPMENT
TO RAIN OR MOISTURE.
ANALOG INPUT BALANCE [ +4dBu ] / UNBALANCE [ -10dBv ] ANALOG OUTPUT BALANCE [ +4dBu ] / UNBALANCE [ -10dBv ]
ONOFF
DATA
MIDI
WORD
SCSI
REMOTE
ANALOG OUTPUT BALANCE [ +4dBu ] / UNBALANCE [ -10dBV ]
ANALOG INPUT BALANCE [ +4dBu ] / UNBALANCE [ -10dBV ]
SCSI terminator
SCSI cable
Removable
SCSI drive
Saving the data using SCSI
This procedure will SAVE/LOAD using a removable SCSI drive disk (zip, MO, DVD-RAM etc.) that is
a backup disk. In save/load using SCSI, the program can be selected separately or in whole.
A backup purpose SCSI disk is generally used after formatted in the backup format, however, a DOS
formatted (computer format) SCSI disk can also be used to SAVE/LOAD in WAV.
Data saved in WAV can be re-loaded and even directly be read by the computer. Therefore, this
kind of data can be used as music software, as well.
Connecting a SCSI device
Refer to the diagram to connect a SCSI device to a D2424.
<Notes on connection>
• Before making connections, make sure that both the recorder and the SCSI drive are turned off.
• One SCSI drive may be connected on the recorder.
• The SCSI connector on the recorder is a half pitch 50-pin connector compatible with Macintosh computers.
Use a cable with connectors that conform to the standards for connecting a SCSI drive.
• The SCSI drive should be terminated. Install a SCSI terminator, or turn the termination switch to “on” if the
drive has a termination switch (like a zip drive).
• You must format the SCSI disk after you connect it to the recorder. Refer to the “Formatting” section on the
next page for the formatting procedure.
D2424
SCSI connector
(Half-pitch 50-pin)
<CAUTION>
In using a removable disk for backup purpose, be sure Write Protect is disabled. Please note that it
cannot be used in the Write Protect mode.
