Installing the Service Processor in the Storage System
The HP 3PAR Service Processor consists of the following:
• A standard HP Server
• A 1U Rail Kit for that specific server
NOTE: The SP ID is the HP 7-digit serial number of the array located on the top front of the server
and in a pull-out placard in the front of the server. The serial number is preceded by SP000. For
example, if the 3PAR serial number is 1614983, enter SP0001614983.
Use these procedures when installing an HP 3PAR Service Processor in an existing rack. Before
you begin, verify that you have the proper service processor 1U Mounting Kit (PN 683811-001).
The service processor rail kit supports a variety of products in round, square, or threaded-hole
racks. The following table identifies any tools required for each type of rack.
Table 4 Rack Types
PictureTools RequiredRack Type
NoneRound hole
NoneSquare hole
ScrewdriverThreaded hole
The following components are included in the kit:
• Slide mounting rails
• Screws
• Cage nuts (for the round-hole rack)
• Cable management straps
• Labels
Installing the Service Processor in the Storage System 27
