Figure 48 Generating SP ID Page
Configure SP Networking
To complete this section, use the completed installation checklist from HP 3PAR StoreServ 7000
Site Planning Manual as reference.
NOTE: For additional information and help, use the HP 3PAR SmartStart online help (accessible
by pressing F1).
1. Enter the SP information for the following fields:
• Service Processor hostname
• IP Address
• Subnet Mask
• Gateway
2. If applicable, check the Enable DNS Support box and provide the values for the following
fields:
• Domain Name
• DNS Server(s)
To adjust the network speed, expand the Advanced option to change the settings.
If you are setting up a VSP in DHCP network environment, enter the permanent IPv4 address
you want to assign to it.
CAUTION: Be sure to enter the permanent SP IP address. If you continue to use the temporary
SP IP address, you may prevent additional system setups from being completed successfully.
56 Setting Up the Service Processor and Storage System
