1-8
Introducing the ProCurve Series 8200zl Switch
Front of the Switch
Introducing the ProCurve
Series 8200zl Switch
LED Mode Select
(5 green LEDs)
Act Indicates that the port Mode LEDs are displaying network activity information.
FDx Indicates that the port Mode LEDs are lit for ports that are in Full Duplex Mode.
PoE Indicates which ports are supplying PoE power.
• If the Mode LED is on the port is providing PoE power.
• If the Mode LED is off the port is not providing PoE power.
• If the Link LED is on the port is enabled for PoE.
• If the Link LED is off the port is disabled for PoE.
• If the Link LED is blinking, the port has an error or the port is denied power due
to insufficient power.
Spd Indicates the Port LEDs are displaying the connection speed at which each port
is operating:
• if the Port LED is off, the port is operating at 10 Mbps
• if the Port LED is blinking, the port is operating at 100 Mbps
• if the Port LED is on continuously, the port is operating at 1000 Mbps
Usr Reserved for future development
Modules A-L (green
- letters
corresponding to
the switch module
slots)
In PoE Mode:
On A module is installed in the switch module slot corresponding to the letter and
the module is undergoing or has passed self test. This also occurs when you
install a module when the switch is already powered on (“hot swap”).
Off A module is not installed in the switch module slot corresponding to the letter.
Blinking
1
On green
Blinking
orange
1
Blinking
orange
2
Off
The module status LED flashes very briefly when a module is being hot swapped.
If the LED flashes for a prolonged time, the module in the slot corresponding to
the letter has failed self test or encountered some other fault condition. See
chapter 5, “Troubleshooting” for a more information.
PoE is ok for this slot.
PoE internal fault for this slot.
PoE load fault or insufficient power for this slot.
The module in this slot is not a PoE module.
1
The blinking behavior is an on/off cycle once every 1.6 seconds, approximately.
2
The blinking behavior is an on/off cycle once every 0.5 seconds, approximately.
